CipherLab 1266 Manual do Utilizador descarregar pdf (Página 69)

SERIAL COMMANDS

#@nnnn<CR>

Purpose To configure the scanner.

Remarks nnnn – the four digits of command parameters. For example, “9952” is to list the

current Code ID settings.

“0x23” + “0x40” + “0x39” + “0x39” + “0x35” + “0x32” + “0x0d”

#@ - - - -<CR>

Purpose To halt the scanner.

Remarks “0x23” + “0x40” + “0x2d” + “0x2d” + “0x2d” + “0x2d” + “0x0d”

#@ . . . . <CR>

Purpose To resume operation.

Remarks “0x23” + “0x40” + “0x2e” + “0x2e” + “0x2e” + “0x2e” + “0x0d”

#@////<CR>

Purpose To respond with a beep.

Remarks “0x23” + “0x40” + “0x2f” + “0x2f” + “0x2f” + “0x2f” + “0x0d”

EXAMPLE

Send the serial commands via RS-232 interface or Bluetooth SPP. For example, run HyperTerminal

on the host computer.

 For the scanner to change the buzzer frequency to 2 kHz and beep –

#@0048<CR>

#@////<CR>

 For the scanner to change the buzzer frequency to 8 kHz and beep –

#@0046<CR>

#@////<CR>

Appendix III

HOST SERIAL COMMANDS

1 2 ... 64 65 66 67 68 69 70 71 72 73 74

Sem comentários

CipherLab 1266 Manual do Utilizador Página 69